The instruction is for retrofitting locking system in Ralaflex access chambers
Lockingdevice Ralaflex Locking system Retrofit – art nr 1104044
Note! If the owner of the facility applies a unique locking system the product above should be replaced with the corresponding customer unique locking device
Tool key for Ralaflex Locking System – art nr 1104046
Note! If the owner of the facility applies a unique locking system the owner need to be contacted for access to a corresponding customer unique tool key.
Block key size 17
Block key size 30
Lift tool, Cast iron cover and frame, hinged – art nr 7000003
Lockingdevice Ralaflex Locking System Retrofit includes
Open lid 1 and place it in secure open position
Mount locking bolt with 1 washer
Use tool key and rotate to open position. Fix the tool key in open position.
If the tool key does not reach all the way one extra washer can be added on the key side
With the tool key fitted 2 washers and locknut M20
Block key size 30 is used tighten the M20 locknut
Hold the bolt with the tool key and tighten the M20 locknut. Do not tighten to hard for the lock bolt to rotate easy enough with the spring
Mount the spring. It should be outside the M20 locknut.
Fit the lock hook
Mount the spring around the lock hook
Add a washer inside a M10 locknut outside of the lock hook. Block key size 17 is used to tighten the locknut M10
Hold the lockning bolt with the tool key and tighten the M10 locknut
Mount the tool key with the always-open latch and close the coverCheck the function of the lock by closing the cover and take the tool key out. The try to open the cover with the lifting tool.
The lock shall rotate safely holds the cover in place. If the lock does not rotate the M20 locknut has to be loosened so the lock rotates by the force of the spring.